sales
Repainting Electrical Panels
We have been asked to recondition and repaint electrical panels. Can you provide the right paint type and specifications for this job?
Read MoreNeed a Different Mass Finishing Method
I have 4,000 parts/day of a flat stamping, much like a large flat washer. The problem is that the parts stick together and many of them only get finished on one side. What are your suggestions?
Read MorePainting Stainless Steel Flexible Tubing
I am looking for a method to paint stainless steel flexible tubing for gas and water lines. We have made a few attempts to paint them, however, since the tubing is flexible stainless steel, every time we bend it, it makes a cracking noise, which is most likely the paint cracking from the bending. What methods/processes are there to have this not occur, and what paint is necessary?
Read MoreNozzle Maintenance for Finishing Fitness
A look at common problems with spray nozzles, and how to minimize them.
Read MorePassivate Using Different Materials
Can I passivate assembled parts with two different materials?
Read MoreNanoceramic Pretreatment
I have been informed about nanoceramic pretreatment prior powder painting. Any experience? Is it really good? Where is the catch?
Read MoreIron Phosphate—Rinsing Required?
My question is must iron phosphate be rinsed before painting. What problems might I have if not rinsed?
Read MoreHydrogen Embrittlement Problems
We are buying screws according to customers specs. The manufactured parts then go through the following steps: remove the copper, heat treatment, and passivation. After all this, the parts come to the final test. The result is hydrogen embrittlement which now means that the parts are scrap. What can be the reason of this problem and is there a change to retreat the parts?
Read MoreMagnesium Pretreatment
Are there any books or literature available for proper surface pretreatment of magnesium prior to painting?
Read More
