CCAI Twin Cities Expo Draw Large Crowd
Held with the Minnesota Technical Assistance Program (MnTAP) at the University of Minnesota at Century College in White Bear Lake.
Expo organizers Deb Savage, Jim Docken, Tim Milner, Paul Pagel and Jim Henningsen.
The Twin Cities chapter of Chemical Coaters Association International (CCAI) and the Minnesota Technical Assistance Program (MnTAP) at the University of Minnesota hosted a symposium and a paint and powder coating expo at Century College in White Bear Lake, Minnesota on March 18-19.
The symposium was held on March 18 and focused on "Maximizing Performance from Individuals and Teams," presented by Judy Hartley, an independent performance consultant/facilitator specializing in leadership and team development and an Adjunct Faculty Member, University of Minnesota, Carlson School of Management and a member of the Manufacturers Alliance.
Anne Goyer Opens MN Expo with Key Note Address.
Also on Wednesday, the Iowa Waste Reduction Center provided painter training, where trainers worked with attendees to improve finishing techniques on virtual reality spray equipment. The training covered the fundamentals of spray application and focused on best practices to optimize spray technique to improve productivity, reduce rework and defects, and decrease air emissions.
The Expo included a vendor show, hands-on demonstrations and technical seminars.
Expo floor exhibit activity.
Virtual Reality Painter Training.
Related Content
-
Can You Afford to Not Use Custom Masking?
Are you weighing the costs of a custom masking solution vs. an off-the-shelf solution? Christy Schulthess of Custom Fabricating & Supplies discusses the overall savings that can be realized with custom masking.
-
High Temp Alignment Masking Discs
Designed with printed alignment “target” rings for easy application, PCX-SH Series powder peel green discs from Caplugs ensure pinpoint accuracy when centering over any hole.
-
Masking Solutions for Medical Applications
According to Custom Fabricating and Supplies, a cleanroom is ideal for converting, die cutting, laminating, slitting, packaging and assembly of medical-grade products.
