Contact
Application of a Second Coat of Powder
Why am I not getting good attraction to the surface or a consistent second coat?
Read MoreComparing Blasting to Conversion Coatings
How complicated is it to apply a phosphate coating?
Read MoreColor Change Time in a Powder Booth
We have seen booths that are supposed to be able to color change in 12 to 15 minutes, reclaim to reclaim. Is this true?
Read MoreWood Grain Appearance in Powder
One of our customers is facing a problem in getting an accurate finish in a wood-look finish.
Read MoreTesting to Compare Powder against Liquid Paint
Do you know of any testing that has been done to compare powder coating to outdoor exposure specifications?
Read MoreAAMA Specifications and Aluminum Railing
Is it correct to assume that AAMA 2604 is suitable for an aluminum railing application and AAMA 2605 is not?
Read MoreImpact of Heat on Chromate Conversion Coating
Will the internal trivalent chromate conversion coatings that are not protected by the CARC paint degrade and become less non-conductive or resistant to corrosion?
Read MorePowder on the Seacoast
After about 18 months of exposure, the powder coating has deteriorated and broken down. There are areas where the coating is blistering, and exposed metal is beginning to rust. Can you give us any advice or information as to why the coating may have broken down in such a short length of time?
Read MoreThe Best Method for Coating Aluminum Extrusions
How do powder coaters paint for less than liquid paint? And which is better, at high volume production, a vertical line, or a horizontal line?
Read MorePowder on Anodized Aluminum
Is there a powder coating that will hold up to Skydrol 500 B4 and Skydrol LD4
Read MoreWhat Issues Affect Transfer Efficiency?
My boss has asked me to develop a plan to improve our transfer efficiency on our powder line. Our 12 automatic guns are over six years old and we have pretty good success with them. According to what I hear and read we should be getting better results.
Read MoreHow to Remove Powder from a Mask
What is the best way to quickly and effectively remove powder residue from magnets so it can be reused without leaving powder residue on the surface of the next part?
Read More
