Parts Cleaning
E-Coat Stains
We are facing a problem of bad marks on our final e-coated automotive parts, which are most probably caused by dripping ultra filtrate.
Read MoreCorrosion Blisters
After 500 hours of salt spray SS testing of our electrocoated parts, we see many blisters but little corrosion increase from the test X-Cut.
Read MoreTrailer Prep
What advice could you give me on steel prior to primer and painting of our trailers. I think ideally I would like to “treat” the steel as it arrives from the supplier, before we work it.
Read MoreBright-Dipping Brass
Our company has to make a major decision because we are going to try and replace the nitric acid (20%) bright dip line that we have used to clean brass fittings for the last 40 years.
Read MoreCleaning Expanded Stainless
We’re looking to install an in-line (or off-line) cleaning system that would degrease flat expanded metal sheet made out of 0.015-inch-thick SS T409 material.
Read MorePlating Strip
I have a part made from Monel that was plated with nickel strike and silver plated. I need to strip the plating from the outer diameter and leave the inner diameter plated without attacking the base metal. Any suggestions?
Read MoreE-coat Pretreat
I’m looking for an environmentally friendly pretreat for reinforcing rods that are to be epoxy coated on a conveyor line. What is available in the market that can increase my cathodic E-coat performance?
Read MoreVariation In Salt-Spray Results
Our chemical supplier is telling us that variations in steel from different mills can produce huge differences in salt-spray results even though it is all cold rolled commercial quality steel. How much truth is there to this, and is there anything specific to look for, or is it a matter of doing extensive testing with materials from various mills?
Read MoreHeat-treated Parts and E-coat
Heat treated parts paint a little differently than plain steel parts, so I will try to explain the differences.
Read More
Closed-Loop Cleaning/Pretreatment
System fits with 'keep it simple' powder coating philosophy
Read More
