Powder Coating
Stripping Powder-Coated Aluminum
I was wondering if you could recommend a process or chemical solution to strip powder-coated aluminum.
Read MoreZinc-Rich Primer
Is there any benefit in using a zinc-rich powder primer under a TGIC powder top coat on aluminum substrates such as sand castings, die castings, and extrusions? If so, I would appreciate any test data quantifying what extension in service life can be expected versus just a TGIC top coat on these aluminum substrates.
Read MoreFinding Specifications
I would like to find out where I can locate the powder coating specification that you referenced in this article.
Read MoreAir Quality
I am currently designing a fluidized bed tank for PVC powder dipping, but I don’t know what temperature air inlet is required. And does the air inlet system need an oil and water filter?
Read MoreConductive Primer
Do you know if there is some metallic coat or adhesive bonding (conductive surface) available that will allow the powder coating application?
Read MorePaint For Qutdrive
For this application, if done properly, can powder coating equal or exceed the performance submerged in saltwater of Dupont Imron?
Read More
Masking Plugs: Cost Effective?
Is there an alternative coating that can be used in the weld nut that’s not detrimental to the assembly and will absolutely not allow powder to stick to the threads? Are there any other alternatives to masking the threads with plugs that would be less costly?
Read MoreEpoxy Peeling Problem
After running the parts through a sterilization cycle, I lose the bond and the epoxy—it can be picked off with your fingers.
Read More
