racking
Uniform Film Thickness
How can we set up our racks and adjust our spray guns to get more uniform powder coating coverage?
Read MorePowder Material Utilization
We do recover some powder, and other colors are low volume, so we do not bother to recover them for reuse. But we are still throwing away a lot of material every year. Any suggestions on how we can get more value out of our powder?
Read MoreSmall Parts Powder Coating System
We are thinking of installing a new small parts powder coat system. Some of our executives are asking why we are not tearing down and moving to our facility a sister site’s 12-year-old system that’s 300 miles away and has a 4 × 6-ft part window formerly used to paint larger frames.
Read MoreGetting a Good Finish Begins with a Great Start
Virtually all metal parts and many plastic parts have some sort of finish applied to them. These finishes are applied to improve appearance, increase corrosion resistance and enhance wear resistance.
Read MoreUniform Film Build
We cannot get uniform and consistent powder coverage up inside that two-inch deep channel.
Read MoreE-Coat Stains
We are facing a problem of bad marks on our final e-coated automotive parts, which are most probably caused by dripping ultra filtrate.
Read MoreMeeting the E-Coat Racking Challenge
Boosting productivity is an ongoing challenge on any industrial finishing line, especially those lines where racks have to be reconfigured to accommodate different sized parts.
Read More
Closed-Loop Cleaning/Pretreatment
System fits with 'keep it simple' powder coating philosophy
Read More
